AquaGuard
Broker: connecting
Sensor: waiting
DEMO MODE: simulated data, not from the ESP32
Can't reach the broker yet. Check your internet, turn off ad-blockers for this page, and try Chrome or Edge. Some school or office networks block port 8884.
0leak confidence %
All quiet. No leaks.
AquaGuard watches your water line for slow, steady trickles that normal use never causes.
New here? Start in 3 steps
1
Start the sensor
Open the Wokwi project and press Play until the console says MQTT OK.
Start the sensor
Open the Wokwi project and press Play until the console says MQTT OK.
2
Match the topic
The topic in Settings below must equal BASE in main.py.
Match the topic
The topic in Settings below must equal BASE in main.py.
3
Fake a leak
Hold the flow dial at about 15% and watch AquaGuard react.
Fake a leak
Hold the flow dial at about 15% and watch AquaGuard react.
No hardware needed. The demo uses simulated data.
Flow
0.00
litres / minute
Pressure
0.0
psi
Water lost
0.00
litres since the leak began
Main valve: OPEN
Main line
Last few minutes
Events
- Nothing yet. Events appear here the moment AquaGuard notices something.
Settings
Broker: broker.hivemq.com (public, over secure WebSockets).